9. Slide the expansion-card holder by pressing on the tab, to support the expansion card on riser 2.10. Slide the expansion-card latch into position.11. If applicable, connect cables to the expansion card.12. Close the system.13. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.14. Install any device drivers required for the card as described in the documentation for the card.Removing Expansion-Card RisersCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet andperipherals.2. Open the system.3. If installed, remove an expansion card from the riser.If installed, remove the iDRAC Ports card from expansion-card riser 1.4. Holding the touch points, lift the expansion-card riser from the riser connector on the system board.Figure 33. Removing and Installing the Expansion-Card Riser 11. expansion-card riser 12. expansion-card riser touch points (2)3. guide pins (2)4. expansion-card riser 1 connector68
