128 Installing System ComponentsInstalling the Integrated Storage Controller CardCAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and simple repairs as authorized in yourproduct documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized by Dell is not coveredby your warranty. Read and follow the safety instructions that came with theproduct.1 Turn off the system, including any attached peripherals, and disconnectthe system from the electrical outlet.2 Open the system. See "Opening the System" on page 84.3 Hold the card by its edges and angle it between the alignment guides onriser 1 until it is fully seated.4 Connect the SAS data cable to the SAS data cable connector on theintegrated storage controller card. See Figure 3-20.NOTE: Ensure that you connect the cable according to the connector labelson the cable. The cable does not function properly if reversed.5 Route the SAS data cable through the channel on the inner side of thechassis.6 Attach the cable labeled "SAS A" to connector SAS A on the backplane,and attach the cable labeled "SAS B" to connector SAS B on the backplane.See Figure 3-20.7 Close the system. See "Closing the System" on page 85.8 Reconnect the system to its electrical outlet and turn the system on,including any attached peripherals.VFlash Media (Optional)The VFlash media card is a Secure Digital (SD) card that plugs into theoptional iDRAC6 Enterprise card at the back corner of the system.Installing a VFlash Media Card1 Locate the VFlash media slot at the back corner of the system.2 With the label side facing up, insert the contact-pin end of the SD cardinto the card slot on the module.
