Removing the integrated storage controller cardPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.NOTE: If applicable, remove the other PCIe cards prior to removing the storage controller card.1. Ensure that you follow the Safety instructions.2. Follow the procedure listed in Before working inside your system.3. If installed, remove the left expansion card riser.4. Remove the Network Daughter Card (NDC) riser.NOTE: The storage controller card is located next to the power supply bay, under the clamp.Steps1. Press and open the clamp.2. Hold the storage controller card by its edges and lift to remove it from the connector on the systemboard.3. To disconnect the SAS cables connected to the card:a. Press down and hold the tab on the SAS cable connector.b. Pull the SAS cable out of the connector.107
