1. clamp slot on the power supply bay 2. clamp3. SAS connector 4. storage controller card battery5. storage controller card 6. storage controller card connector onthe system boardNext stepsInstall the integrated storage controller card.Related TasksRemoving the left expansion card riserRemoving the NDC riserInstalling the integrated storage controller cardInstalling the integrated storage controller cardPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.CAUTION: Ensure that the storage controller card is installed carefully, so that the componentson the card are not damaged.Ensure that you follow the Safety instructions.Steps1. Reconnect the SAS data cables to the card.NOTE: Ensure that you connect the cable according to the connector labels on the cable. Thecable does not function properly if reversed.2. Hold the card by its edges, and align the card edge connector with the connector on the systemboard.3. Lower the card into the system until the card is firmly seated.4. Route the SAS data cable through the channel on the inner side of the chassis.5. Connect the SAS cables from the storage controller card to the connectors on hard drive backplaneor SAS expander card based on the hard drive configuration selected. For more information aboutcabling images, see Removing the hard drive backplane.6. Close the clamp.Next steps1. Install the NDC riser.2. If removed, install the left expansion card riser.3. Follow the procedure listed in After working inside your system.Related TasksInstalling the NDC riserInstalling the left expansion card riser108