Menu Item DescriptionPort C Sets the drive type of the selected device. For Embedded SATA settingsin ATA mode, set this field to Auto to enable BIOS support. Set it to OFFto turn off BIOS support.For AHCI mode or RAID mode, BIOS always enables support.Model Displays the drive model of the selected device.Drive Type Displays the type of drive attached to the SATA port.Capacity Displays the total capacity of the hard drive. The field is undefined forremovable media devices such as optical drives.Boot Settings screenYou can use the Boot Settings screen to set the Boot mode to either BIOS or UEFI. It also enables you tospecify the boot order.To view the Boot Settings screen, click System Setup Main Menu → System BIOS → Boot Settings.The Boot Settings screen details are explained as follows:Menu Item DescriptionBoot Mode Enables you to set the boot mode of the system.CAUTION: Switching the boot mode may prevent the system frombooting if the operating system is not installed in the same bootmode.NOTE: Setting this field to UEFI disables the BIOS Boot Settingsmenu. Setting this field to BIOS disables the UEFI Boot Settingsmenu.If the operating system supports UEFI, you can set this option to UEFI.Setting this field to BIOS allows compatibility with non-UEFI operatingsystems. By default, the Boot Mode option is set to BIOS.Boot Sequence Retry Enables or disables the Boot Sequence Retry feature. If this field isenabled and the system fails to boot, the system reattempts the bootsequence after 30 seconds. By default, the Boot Sequence Retry optionis set to Enabled.Hard-Disk Failover Specifies the devices in the Hard-Disk Drive Sequence that areattempted in the boot sequence. When this option is set to Disabled,only the first hard disk device in the list is attempted to boot. When set toEnabled, all hard disk devices are attempted to boot, as listed in theHard-Disk Drive Sequence. This option is not enabled for UEFI BootMode.Boot Option Settings Configures the boot sequence and the boot devices.32
