Item Connector Description15 DDR DIMM memory slots (4) DIMM slots 1–416 PWR_SW Power switch connector17 POWER P1 power connector18 SATA2 SATA2 connector19 SATA3 SATA3 connector20 HDD_ODD_POWER HDD_ODD power cable connector21 SATA0 SATA0 connector22 SATA1 SATA1 connector23 USB 3_FRONT Front USB 3.0 connector24 THRM Thermal sensor connectorDisabling A Forgotten PasswordThe system's software security features include a system password and a admin password. The passwordjumper disables any password(s) currently in use.1. Open the system.2. Identify the PSWD jumper on the system board.3. Remove the PSWD jumper from the system board.NOTE: The existing passwords are not disabled (erased) until the system boots without thejumper.4. Install the cover.NOTE: If you assign a new system and/or admin password with the PSWD jumper installed, thesystem disables the new password(s) the next time it boots.5. Connect the system to the electrical outlet and power-on the system.6. Power off the system and disconnect the power cable from the electrical outlet.7. Remove the cover.8. Replace the PSWD jumper on the system board.9. Close the system.10. Power on the system.11. Go to the system setup, and assign a new system or admin password.For information on assigning a system or admin password, see Assigning A System And AdminPassword.75
