Dell PowerVault 50F Installation And Troubleshooting Manual

Also see for PowerVault 50F: Connection guide User guide Install guide Installation and troubleshooting guide User guide

Contents

Dell PowerVault 50F Installation And Troubleshooting Manual Manual pdf 100 page image

5-2 Installation and Troubleshooting GuideTo retest a port which has been marked ;03, clear the port and set to %Kusing thediagClearError < > command. This command clears the port status only anddoes not clear the logs or change the port’s condition. The diagClearError < >command should only be used during diagnostic procedures to reset a bad port forretest.For more detailed error message information, see Appendix A, “Error Messages.”) ' Telnet commands (see Chapter 4, “PowerVault 56F 16-Port Fibre Channel SwitchCommands”) are available to determine the switch’s status, error conditions, andswitch operating statistics.The diagnostic procedures are completed using commands during a Telnet session.) . Various loopback paths are built into the switch hardware for diagnostic purposes. Aloopback path test within the switch verifies the proper internal Fibre Channel Port(FCP) logic functions and the paths between the interfaces and central memory. #Error messages are stored in RAM and are lost when power is removed from theswitch. Access the error message log to view and note any error messages beforeremoving power from the switch. ' The following status activity indicators apply to G_Port and FL_Port interface cards.NOTE: FL_Port interface cards have an additional green light-emitting diode (LED) (vis-ible from the front of the switch) to identify them from G_Port interface cards.. 6& #) The color and flash speed of the power LED, as described in Table 5-1, indicates theswitch’s status.