Dell PowerVault 50F Installation And Troubleshooting Manual

Also see for PowerVault 50F: Connection guide User guide Install guide Installation and troubleshooting guide User guide

Contents

Dell PowerVault 50F Installation And Troubleshooting Manual Manual pdf 77 page image

support.dell.com PowerVault 56F 16-Port Fibre Channel Switch Commands 4-21 #The ifShow command displays a summary of currently running tasks. The displayincludes three sections organized by interface: — Ethernet 10/100BASE-T port — Loopback interface — Fibre Channel; this section is omitted if IP over Fibre Channel is notconfigured%!The following example shows the ipAddrSet command, which sets the switch’sEthernet IP address, Ethernet subnetmask, Fibre Channel IP address, Fibre Channelsubnetmask, and gateway address. The fields are described in Table 4-11.NOTE: Consult your network administrator for the appropriate IP address(es), subnet-mask(s), and gateway address.switch:admin> ipAddrSetEthernet IP Address [192.168.90.241]:Ethernet Subnetmask [none]:Fibre Channel IP Address [192.168.65.241]:Fibre Channel Subnetmask [none]:Gateway Address [192.168.90.1]:( 0'' !!'' % Ethernet IP address The default IP address on a new switch is a tempo-rary number derived from the switch’s World WideNames (WWN); enter a valid IP addressEthernet subnetmask The Ethernet subnetmask value; the default subnet-mask value is none; see your network administratorfor the appropriate subnetmask value to enter hereFibre Channel IP address The Fibre Channel IP address for the switch; enter avalid IP address (not currently supported)Fibre Channel subnet-maskThe Fibre Channel subnetmask for the switch; thedefault is noneGateway IP address The gateway IP address; the default gateway addresson a new switch is none; you must enter a valid gate-way address, if required