Dell PowerVault 50F Installation And Troubleshooting Manual
Also see for PowerVault 50F: Connection guideUser guideInstall guideInstallation and troubleshooting guideUser guide
                                                                                                                                                                            | |
Contents
| 
4-28 Installation and Troubleshooting GuideThe reboot command reboots the switch to the stored configuration in flash memoryand takes about 1 1/2 minutes. The switch may be in any operational state (enabled ordisabled) before rebooting.While the switch is rebooting, the Telnet session is closed and all FCPs become inac-tive. If the switch was part of a fabric, the remaining switches reconfigure.# & The switchDisable command is used to take the switch offline for diagnostic tests,maintenance functions, or replacing a faulty switch.You can observe and verify this process by watching the front panel light emittingdiodes (LEDs) change color from green to slow flashing amber as each port goesinactive.# 6The switchEnable command enables the switch and provides fabric information. Theswitch may need to be enabled after maintenance and diagnostic tests.The switch is enabled with a fabric domain ID of 1. After the fabric is reconfigured thisswitch is the principle address manager that is capable of assigning domain IDs toother switches in the same fabric.You can observe and verify this process by watching the front panel LEDs changecolor from slow flashing amber to green as each port goes active.# "The following example shows the switchName command screen, which displays orsets the switch’s name. If a new name is specified and it is enclosed in quotes, thecommand sets the switch to that name. If no new name is included, the commanddisplays the switch’s name.The command syntax is 6 B 8.The switchName command displays the name of the current switch. By supplying anargument, the user may set the name of the current switch.NOTE: This command is only available to admin-level users. 6 48 6 L-M= 4 6 |
Related manuals for Dell PowerVault 50F
Dell PowerVault 50F Installation And Troubleshooting Manual
Dell PowerVault 50F Rack Installation Manual
Dell PowerVault 51F Rack Installation Manual
Dell PowerVault 705N Install Manual
Dell S6000–ON Troubleshooting Manual
Dell PowerVault 50F User Manual
Dell PowerSwitch S4048-ON Installation Manual
Dell PowerConnect B-RX16 Installation Manual
Dell PowerSwitch S4128F-ON Installation Manual
Dell Brocade Adapters Troubleshooting Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine