4-14 Dell PowerVault 51F 8-Port Fibre Channel Switch Installation and Troubleshooting GuideconfigDefaultThe configDefault command is used to reset some of the switch configuration valuesto their factory default values. In addition, this command configures the switch toboot from its internal firmware if it has been previously configured to boot from thenetwork. This command may not be executed on an enabled switch; you must firstdisable the switch using the switchDisable command.switch:admin> configDefaultCommitting configuration...done.Because some configuration parameters are cached by the switch, it is recommendedthat the switch be rebooted immediately following the execution of configDefault, orunexpected behavior may result. With the exception of the following parameters, allconfiguration parameters are reset to their default values:• World Wide Name• Ethernet MAC address• Ethernet IP address and subnetmask• IP gateway address• OEM customization• SNMP configuration• Zoning configuration• License keys• System nameconfigShowThe configShow command displays the current settings of many of the switch's con-figurable parameters. The output of the command is broken up into two sections; thefirst displays the switch's boot settings and the second displays other configurationparameters, most of which are set from the configure command.NOTE: The entry shown for the lcdContrast parameter is set when the switch is man-ufactured and is not user-configurable.dateThe date command displays the system date and time. To set the date, perform thefollowing steps:1. Type date followed by the date in the order of mmddHHMMyy where:a. mm is the monthb. dd is the datec. HH is the hour
