support.dell.com PowerVault 51F Commands 4-31syslogdIpThe syslogdIp command sets or displays the switches system log daemon IPaddress. The command syntax is syslogdip <ip address>.tempShowThe following example shows the tempShow command screen, which shows theswitch’s temperature as measured by five sensors on the system board.Port state The port state follows the GBIC type. The possible port statesinclude:• No_Card — No card present in this switch slot• No_Module — No GBIC module in this port• No_Light — The module is not receiving light• No_Sync — The module is receiving light but is out ofsync• In_Sync — The module is receiving light and is in sync• Laser_Flt — The module is signaling a laser fault (defec-tive GBIC)• Port_Flt — The port has been marked faulty (defectiveGBIC, cable, or device)• Diag_Flt — The port failed diagnostics (defective G_Portor FL_Port card or system board)• Online — The port is up and running• Lock_Ref — The port locking to the reference signal• Testing — Running diagnosticsComment field The comment field follows the port state. The possible com-ments include:• Disabled — The port is disabled• Loopback — The port is in loopback mode• E_Port — The WWN and switch name of the otherswitch is shown, the use of this Inter Switch Link (ISL) isshown (see FC_SW)• F_Port — The WWN of the N_Port is shown• G_Port — The port is online but is not yet an E_Port orF_Port• L_Port — The port is connected to an arbitrated loopTable 4-16. switchShow Command Field Descriptions (continued)Field Description
