Dell PowerVault NX3600 Administrator's Manual

Also see for PowerVault NX3600: Manual Owner's manual Command line interface guide Supplementary guide Deployment guide

Contents

Dell PowerVault NX3600 Administrator's Manual Manual pdf 61 page image

The System Identity page is displayed. This page shows the current configuration and whether the NAS clustersolution is already joined to an Active Directory domain.2. In System name, enter the system name.This name identifies the Dell Fluid File System in alerts that the system sends and is also the default name for theDell Fluid File System when you configure Active Directory.3. Select The system is a member of a Microsoft Windows Network if you want Dell Fluid File System to join an ActiveDirectory domain and proceed to the next step. Otherwise, leave this field unselected and click Save Changes.4. In System NetBIOS name, enter the Dell Fluid File System NetBIOS name that is displayed in the networkneighborhood.This name is limited to 15 characters. Use the system name unless otherwise instructed.5. In Domain, enter the domain to which Dell Fluid File System belongs.Use the fully qualified domain name (FQDN), not the NetBIOS domain name. For example: mydomain.company.com6. In User name, enter the administrator user name to be used to join the Active Directory domain.NOTE: This user name is not saved in Dell Fluid File System.7. In Password, enter the administrator password.NOTE: This password is not saved in Dell Fluid File System.CAUTION: Advanced Configuration must be deselected, unless otherwise instructed by Dell support. This fieldallows configuring more Active Directory related parameters.Through the Advanced Configuration option, you can specify a domain controller to override the default controllerselected by the system.8. Click Save Changes.Network Configuration OverviewTo access the system you need to define an IP address your clients can access. It is recommended to also add this IPaddress to your DNS server so that clients can access the system via a name in addition to an IP address.NOTE: You must configure CIFS to authenticate users after joining the Domain. To authenticate users, ClusterManagement → Protocols → CIFS Configuration. Select the radial for Authenticate users' identity using ActiveDirectory and local user database.NOTE: The Client Access VIP is configured during initial configuration using the Dell NAS Initial Deployment Utility.You can see the address you configured by going to the NAS Manager Cluster Management → Network →Subnets. Click Primary at the bottom of the page to see the client access VIP labeled VIP address.Since the system's architecture is a cluster of two or more controllers, this IP address is a virtual IP address (VIP) whichserves every controller in the cluster. This allows clients to access the system as a single unit, enables the system toperform load balancing between controllers, and additionally allows services to continue even if a controller fails.Clients benefit from the system's high availability and high performance.Client users access the system through a variety of network topologies. Depending on the physical capabilities of thenetwork infrastructure, the NAS cluster solution:• Belongs to all LAN or client subnets. From a performance perspective, this is the most optimal configuration. Insuch network configurations, it is sufficient to define one client access virtual IP address (VIP) for each subnet.• Does not belong to any of the LAN or Client subnets, in which case all clients are considered routed. In suchsituations, the clients access the data via a router or layer 3 switches. In such network configurations it isrecommended to define multiple client access virtual IP addresses in a single subnet, and provide somemechanism for clients to select an IP address from that list.61