Dell PowerVault NX400 Owner's Manual

Also see for PowerVault NX400: Manual Getting started guide Troubleshooting guide Administrator's guide Setting up

Contents

Dell PowerVault NX400 Owner's Manual Manual pdf 49 page image

Installing The Optical Drive In Hot-Swappable Hard-Drive SystemsCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. If installed, remove the front bezel.2. Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet.3. Open the system.4. To remove the optical drive blank, press the blue release tab at the back of the blank and push the blank out of thesystem.5. Align the optical drive with the optical drive slot on the front of chassis.6. Slide the optical drive into the slot until the latch snaps into place.7. Connect the power/data cable to the back of the drive.8. Route the power/data cable underneath the cable routing latch of the system.9. Connect the power/data cable to the connectors on the system board.10. Close the system.11. If applicable, install the front bezel.12. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.Cooling FansYour system supports:• Four cooling fans in a non-redundant power supply configuration.• Five cooling fans in a redundant power supply configuration.NOTE: Fan 1 must be installed in a redundant power supply configuration.NOTE: Hot-swap removal or installation of the fans is not supported.NOTE: In the event of a problem with a particular fan, the fan number is referenced by the system’s managementsoftware, allowing you to easily identify and replace the proper fan by noting the fan numbers on the coolingshroud.Removing A Cooling FanWARNING: Opening or removing the system cover when the system is on may expose you to a risk of electricshock. Exercise utmost care while removing or installing cooling fans.CAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.CAUTION: Do not operate the system with the cover removed for a duration exceeding five minutes.NOTE: The procedure for removing each fan is identical.49