Item Connector Description15 PWR_CONN_1 Power connector16 Fan2 Cooling fan connector17 A1, A4, A2, A5, A3, A6 Memory module sockets18 BP_SIG Backplane signal connector19 PWR_CONN_2 Power connector20 CPU1 Processor socket21 PDB_CONN Power distribution board connector22 BATTERY Battery connector23 CTRL_PNL_MB Control panel interface connector24 SATA_A-D SAS connector25 SATA_E Optical drive SATA connector26 SAS_A SAS connector27 FP_USB Front-Panel USB connector28 IDSDM Internal Dual SD Module29 SAS_B SAS connectorDisabling A Forgotten PasswordThe system's software security features include a system password and a setup password. The password jumperenables these password features or disables them and clears any password(s) currently in use.CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions that came with the system.1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.2. Open the system.3. Remove the jumper plug from the password jumper.4. Close the system.The existing passwords are not disabled (erased) until the system boots with the password jumper plug removed.However, before you assign a new system and/or setup password, you must install the jumper plug.NOTE: If you assign a new system and/or setup password with the jumper plug still removed, the systemdisables the new password(s) the next time it boots.5. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.6. Open the system.7. Install the jumper plug on the password jumper.8. Close the system.9. Assign a new system and/or setup password.99
