6. Replace the cooling shroud or power distribution board shroud as applicable.7. Close the system.8. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.Internal USB Memory Key (Optional)An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storagedevice. The USB connector must be enabled by the Internal USB Port option in the Integrated Devices screen of theSystem Setup.To boot from the USB memory key, configure the USB memory key with a boot image and then specify the USB memorykey in the boot sequence in the System Setup.NOTE: The internal USB connector (INT_USB) is located on expansion-card riser 2.Replacing The Internal USB KeyCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet andperipherals.2. Open the system.3. Locate the USB connector (INT_USB) on the expansion-card riser 2.4. If installed, remove the USB key.5. Insert the USB key into the USB connector.6. Close the system.7. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.8. Enter the System Setup and verify that the USB key is detected by the system.Figure 19. Replacing the Internal USB Key1. USB memory key2. USB memory key connector51
