Dell Precision WorkStation 210 User Manual

Also see for Precision WorkStation 210: Quick reference guide User guide

Contents

8-12 Dell Precision 210 Desktop Systems User’s Guide5. Insert the new SEC cartridge/heat sink assembly into the system boardconnector.Press the SEC cartridge firmly into its connector until it is fully seated and thelatches snap into place. You must use up to 25 lb of force to fully seat the SECcartridge in its connector. Install or replace the two large thumbscrews thatsecure the heat sink to the system board.6. If necessary, change the processor speed jumper setting (see Figure B-1 tolocate system board jumpers).The processor speed jumper should be set for the installed microprocessor’srated internal speed. For example, for a 350-megahertz (MHz) Intel Pentium IIprocessor, a jumper plug should be installed on the pins labeled “350MHZ.” (SeeAppendix B, “Hardware Configuration Features,” for more information on thejumpers.)7. Rotate the power supply back into position, making sure that the securing tabsnaps into place.8. Replace the computer cover, and reconnect your computer and peripherals totheir power sources and turn them on.As the system boots, it detects the presence of the new processor and automat-ically changes the system configuration information in the System Setupprogram.NOTE: After you remove and replace the cover, the chassis intrusion detector willcause the following message to be displayed at the next system start-up:ALERT! Cover was previously removed.9. Enter the System Setup program, and confirm that the system data area correctlyidentifies the type and number of installed processor(s).See Chapter 3, “Using the System Setup Program.”10. While in the System Setup program, reset the chassis intrusion detector bychanging Chassis Intrusion to Not Detected.See Chapter 3, “Using the System Setup Program,” for instructions.NOTE: If a setup password has been assigned by someone else, contact yournetwork administrator for information on resetting the chassis intrusion detector.11. If you installed a second microprocessor and your system is runningWindows NT 4.0, reinstall the operating system.See your Windows NT documentation for instructions.When you reinstall Windows NT 4.0, the operating system detects the secondmicroprocessor.