4. Insert the module into the connector until the module snaps into position.If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.5. Close the computer cover.NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.6. Connect your computer and devices to electrical outlets, and turn them on.7. Press to enter system setup and check the value for System Memory.The computer should have changed the value of System Memory to reflect the newly installed memory. Verify thenew total. If it is correct, skip to step 9.8. If the memory total is incorrect, turn off and disconnect your computer and devices from their electrical outlets. Openthe computer cover and check the installed memory modules to ensure that they are seated properly in their sockets.Then repeat steps 5, 6, and 7.9. When the System Memory total is correct, press to exit system setup.10. Run the Dell Diagnostics to verify that the memory modules are operating properly.Removing MemoryCAUTION: Before you begin any of the procedures in this section, follow the safety instructions located inthe Product Information Guide.NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your bodybefore you touch any of your computer's electronic components. You can do so by touching an unpainted metal surfaceon the computer.1. Follow the procedures in "Before You Begin."2. Press out the securing clip at each end of the memory module connector.3. Grasp the module and pull up.If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.Back to Contents Page
