42 | Setting the IP AddressSetting the IP AddressAssigning an IP AddressYou can select the IP mode from Dual Stack, IPv4, and IPv6. If your network supportsboth IPv4 and IPv6, select Dual Stack.Select the IP mode of your environment, and then set IP address, subnet mask (for IPv4only), and gateway address.CAUTION:• Assigning an IP address that is already in use can cause network communication issues.NOTE:• Assigning an IP address is considered as an advanced function and is normally done by a systemadministrator.• When you assign an IP address manually in IPv6 mode, use the Dell Printer Configuration WebTool. To display the Dell Printer Configuration Web Tool, use the link-local address. To confirm thelink-local address, print a configuration report and check the IPv6 link-local address.See "Information Pages".Assigning an IPv4 Address Using the Control Panel1 Press the button.2 Tap DeviceJConnectivity.3 Do either of the following:If the printer is connected to a network with the Ethernet cable:Tap Ethernet.If the printer is connected to a wireless network:Tap Wi-Fi, and then tap the desired network.4 Tap IPv4.5 Tap the Enable IPv4 slider to turn it on.Make sure that Mode is set to STATIC.6 Tap IPv4 Address.7 Enter the IPv4 address using the number pad, and then tap Enter.8 Tap Gateway Address.9 Enter the gateway address using the number pad, and then tap Enter.10 Tap Subnet Mask.11 Enter the subnet mask using the number pad, and then tap Enter.12 Tap OK, or tap Restart if you change the mode in Step 5.
