Chapter 5 Set up the Storage Center Software130 Storage Center SC8000 Controller Deployment GuideLoad the License FileUse the Load License page to upload the Storage Center license file. The license file makessettings available depending on what features were purchased.1 Browse to the location of the license file.2 Verify that the serial number of the license file matches the serial number of thecontroller by comparing the name of the license file to the title bar of the Startup Wizard.License files use the naming convention snxxx_35_date.lic, where: snxxx is the serial number of the Storage Center. 35 indicates that the system runs software higher than version 3.5. date shows the license generation date in YYMMDD format. .lic is the file extension.3 Select the license file, then click Load License. The Startup Wizard displays a messagewhen the license is successfully loaded. If the license loads successfully, the message The license submission has completedsuccessfully appears. If the message Error: The license file is not valid message is displayed, seeTroubleshooting Licenses on page 206.4 Click Continue. If standard drives are detected, the Create Disk Folder page appears. If Self‐Encrypting Drives (SEDs) that are Federal Information Processing Standard(FIPS) 140‐2 certified are detected, Storage Center formats the drives as if SecureData will be used, and you are asked whether to create a Secure Data folder. SeeAbout Secure Data on page 131. If the No disks could be found message is displayed, see Troubleshooting Enclosureson page 205.
