Chapter 2 Install the Hardware52 Storage Center SC8000 Controller Deployment GuideInstalling 2.5" DrivesInstall 2.5ʺ drive carriers vertically into the 24‐drive enclosure.1 Make sure that the carrier is oriented so that the drive is on the left side and the handleopens from the top.2 Release the carrier handle by pressing the latch in the handle downwards.3 Insert the carrier into the enclosure in the vertical position.Figure 49. 2.5" Drive Carrier Module in Open Position4 Gently slide the carrier all the way into the enclosure until it is stopped by the lever onthe bottom of the carrier.Figure 50. Inserting a 2.5" Drive Carrier Module (1)5 Rotate the handle firmly until the handle fully engages. You will hear a click as the latchengages and holds the handle closed.See AlsoEN‐SASx6x12/24 Standard SAS Drives on page 29EN‐SASx6x12/24 Drive Numbering on page 30
