Dell SuperMassive 9800 Getting Started Manual

Recording Configuration Information | 15Recording Configuration InformationUse this section to record your configuration information. Besure to keep for future reference.The default MGMT interface IP address is 192.168.168.168.Registration InformationNetworking InformationAdministrator InformationInternet Service Provider (ISP) InformationRecord the following information about your current Internetservice:Serial Number: Record the serial number found onthe bottom panel of yourDell SonicWALL appliance.Authentication Code: Record the authentication code foundon the System > Status page,“showstatus” from the CLI, or thebottom panel of your Dell SonicWALLappliance.LAN IP Address:_____._____._____._____Select a static IP address for yourDell SonicWALL appliance that iswithin the range of your local network.(default is 10.10.10.10 for X0/LAN)Subnet Mask:_____._____._____._____Record the subnet mask for the localnetwork. Client devices connectingthrough the appliance are assigned IPaddresses in this network.(default is 255.255.255.0)Ethernet WAN IP Address:_____._____._____._____Select a static IP address for yourEthernet WAN. This setting onlyapplies if you are already using anISP that assigns a static IP address.Admin Name: Select an administrator account name.(default is admin)Admin Password: Select an administrator password.(default is password)If you areconnecting withDHCPNo information is usually required. However,some providers may require a Host Name:_________________________________If you areconnecting withStatic IPIP Address: _____._____._____._____Subnet Mask:_____._____._____._____Default Gateway: _____._____._____._____Primary DNS: _____._____._____._____DNS 2 (optional): _____._____._____._____DNS 3 (optional): _____._____._____._____SuperMassive_9800_GSG.book Page 15 Tuesday, September 9, 2014 7:32 PM