Dell SuperMassive 9800 Getting Started Manual

38 | Configuring a Stateful HA PairInitial High Availability SetupBefore you begin the configuration of HA on the PrimaryDell SonicWALL security appliance, perform the following tasks:• Determine which interfaces should be used as the HA ControlInterface and the HA Data Interface.• HA Control Interface—Can be a 1 Gbps interface only.Note that Link Aggregation and Port Redundancy are notsupported for the HA Control Interface.• HA Data Interface—Can be a 1 Gbps or 10 Gbpsinterface. 10 Gbps is recommended.• On the bottom panel of the appliance that will run as theSecondary device, locate the serial number and write thenumber down. You need to enter this number in the HighAvailability > Settings > HA Devices page.• Verify that the Primary and Secondary appliances areregistered on MySonicWALL and running the same SonicOSversions.• Ensure the Primary and Secondary security appliances’ LAN,WAN, and other interfaces are properly connected for failover.• Connect the HA Control and Data Links on the Primary andSecondary appliances with appropriate cables.• Turn on the Primary Dell SonicWALL security appliance first.Then, turn on the Secondary Dell SonicWALL securityappliance.SonicWALL SuperMassive 9800 CONSOLESDHCMGMT X23 X21X20 X6 X41GE10GE X2 X0X1X3X5X7X22B0B1ALARMTESTPWR 1 PWR 2X14 X12X18 X16 X10 X8X9X11X13X15X17X1980GBSSD80GBSSDSonicWALL SuperMassive 9800 CONSOLESDHCMGMT X23 X21X20 X6 X41GE10GE X2 X0X1X3X5X7X22B0B1ALARMTESTPWR 1 PWR 2X14 X12X18 X16 X10 X8X9X11X13X15X17X1980GBSSD80GBSSDDell SonicWALLHA/Failover PairDell SonicWALL SuperMassive 1Dell SonicWALL SuperMassive 2HA Control LinkLocal NetworkInternetHA Data LinkSuperMassive_9800_GSG.book Page 38 Tuesday, September 9, 2014 7:32 PM