Adding and Replacing Parts 953 Turn the computer right-side up, and then open the display all the way (180 degrees) so that it rests onyour work surface.NOTICE: To avoid damaging the hinge cover, do not lift the cover on both sides simultaneously.4 Insert a scribe in the indent to lift the hinge cover on the right side.5 Ease the hinge cover up, moving from right to left, and remove it.6 To replace the hinge cover, insert the left edge of the cover into place.7 Press from left to right until the cover snaps into place.8 Close the display and turn the computer upside-down.9 Replace the battery. See “Replacing the Battery.”KeyboardCAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the ProductInformation Guide.NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodicallytouching an unpainted metal surface (such as a connector on the back of the computer).1 Follow the procedures in “Before You Begin.”2 Remove the hinge cover. See “Hinge Cover.”1 hinge cover 2 indent12book.book Page 95 Thursday, September 22, 2005 8:08 AM
