relating to electromagnetic compatibility, safety of electrical equipment designed for use within certain voltage limitsand on radio equipment and telecommunications terminal equipment.Compliance is indicated by the CE marking.The manufacturer of this product is: Lexmark International, Inc., 740 West New Circle Road, Lexington, KY, 40550 USA.The authorized representative is: Lexmark International Technology Hungária Kft., 8 Lechner Ödön fasor, MillenniumTower III, 1095 Budapest HUNGARY, A declaration of conformity to the requirements of the Directives is availableupon request from the Authorized Representative.Refer to the table at the end of the Notices section for further compliance information.Regulatory notices for wireless productsThis section contains the following regulatory information pertaining to wireless products that contain transmitters,for example, but not limited to, wireless network cards or proximity card readers.Exposure to radio frequency radiationThe radiated output power of this device is far below the radio frequency exposure limits of the FCC and otherregulatory agencies. A minimum separation of 20 cm (8 inches) must be maintained between the antenna and anypersons for this device to satisfy the RF exposure requirements of the FCC and other regulatory agencies.Notice to users in BrazilEste equipamento opera em carater secundario, isto e, nao tem direito a protecao contra interferencia prejudicial,mesmo de estacoes do mesmo tipo, e nao pode causar interferencia a sistemas operando em carater primario.(Res.ANATEL 282/2001).Industry Canada (Canada)This device complies with Industry Canada specification RSS-210. Operation is subject to the following two conditions:(1) this device may not cause interference, and (2) this device must accept any interference, including interferencethat may cause undesired operation of the device.This device has been designed to operate only with the antenna provided. Use of any other antenna is strictlyprohibited per regulations of Industry Canada.To prevent radio interference to the licensed service, this device is intended to be operated indoors and away fromwindows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is subject tolicensing.The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emitRF fields in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from HealthCanada's Web site www.hc-sc.gc.ca/rpb.Notices127