How can I improve wireless signal strength?A common reason wireless printers fail to communicate over a network is poor wireless signal quality. If the signalis too weak, too distorted, or blocked by an object, it cannot carry information between the access point and theprinter. To determine if the printer is receiving a strong signal from the access point, print a network setup page. TheQuality field indicates the relative strength of the wireless signal the printer is receiving. Drops in signal strength canbe intermittent, however, and although the signal quality appears high, it may drop during certain conditions.If you think signal strength is a problem between your access point (wireless router) and the printer, then try one ormore of the following:Notes:• The solutions below are for infrastructure networks. If you are using an ad hoc network, then adjust the computerwhen the solution suggests adjusting the access point.• Ad hoc networks have a much shorter range than infrastructure networks. Try moving the printer closer to thecomputer if they seem to have trouble communicating.MOVE THE PRINTER CLOSER TO THE ACCESS POINTIf the printer is too far away from the access point, then it will not be able to communicate with other devices onthe network. For most indoor wireless networks, the maximum distance between the access point and the printeris approximately 100 feet (30 meters). This distance could be longer or shorter, depending upon the layout of thenetwork and the limitations of the access point.REMOVE OBSTACLES BETWEEN THE ACCESS POINT AND THE PRINTERThe wireless signal from your access point will pass through most objects. Most walls, floors, furniture, and otherobjects will not block the wireless signal. However, there are materials that are too dense for the signal to passthrough, such as objects containing metal and concrete. Arrange your printer and access point so that the signalis not blocked by such objects.REMOVE SOURCES OF INTERFERENCEOther types of radio frequencies can cause problems with the wireless signal on your network, resulting to printingissues that seem to come and go.• Turn off potential sources of interference where possible.• Avoid using microwave ovens, cordless phones (but not cellular phones), baby monitors, almost any kitchenappliance, wireless surveillance equipment, or any appliance containing a motor when printing over yourwireless network.• If another wireless network is operating in the vicinity, then change the wireless channel on the access point.• Do not place your access point on a printer or other electronic device. Such devices can also interfere with thewireless signal.ARRANGE THE NETWORK TO REDUCE SIGNAL ABSORPTIONEven when the wireless signal is able to pass through an object, it is slightly weakened. If it passes through toomany objects, then it can be significantly weakened. All objects absorb part of the wireless signal when it passesthrough them, and certain types of objects absorb enough to cause communications problems. Place your accesspoint as high in the room as possible to avoid signal absorption.Networking78
