Installing the antenna module (white cable)PrerequisitesIf you are replacing a component, remove the existing component before performing the installation process.About this taskThe following image(s) indicate the location of the antenna module (white cable) and provides a visual representation of theinstallation procedure.Steps1. Push the antenna module (white cable) though the slot the chassis.2. Align the screw hole and captive screw on the antenna module (white cable) to the screw holes on the chassis.3. Tighten the captive screw that secures the antenna module (white cable) to the chassis.4. Replace the screw (M3x3) that secures the antenna module (white cable) to the chassis.5. Route the antenna cable through the routing guides on the chassis and system board.Next steps1. Install the hard drive, if applicable.2. Install the side cover.74 Removing and installing Field Replaceable Units (FRUs)