Steps1. Move the securing clip away and place the OSD board until it locks in to the display bezel.2. Adhere the tape that secures the OSD board cable to the middle frame.3. Connect the cable to the connector on the system board.4. Close the latch to secure the cable.Next steps1. Install the vesa-mount bracket.2. Install the back cover.3. Install the stand.4. Follow the procedure in After working on your thin client.Solid-state driveRemoving the solid-state drivePrerequisites1. Follow the procedure in Before working inside your thin client.2. Remove the stand.3. Remove the back cover.About this taskThe following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure.20 Removing and installing components
