Steps1. Align the notch on the wireless card with the tab on the wireless-card slot and slide the card into the slot.2. Connect the antenna cables to the wireless card.3. Slide the wireless-card bracket over the wireless card.4. Align the screw hole on the wireless-card bracket with the screw hole on the wireless card.5. Replace the screw (M2x3.5) that secures the wireless-card bracket and the wireless card to the system board.Next steps1. Replace the back cover.2. Replace the stand.3. Follow the procedure in After working on your thin client.Heat sinkRemoving the heat sinkPrerequisites1. Follow the procedure in Before working on your thin client.2. Remove the stand.3. Remove the back cover.About this taskThe following image indicates the location of wireless card and provides a visual representation of the removal procedure.NOTE: Depending on the configuration you ordered, the number of screws and the appearance of the heat-sinkassembly may differ.26 Removing and installing components