About this taskThe following image indicates the location of the rubber feet and provides a visual representation of the installation procedure:Steps1. Align the screw holes on the rubber foot with the screw holes on the display bezel.2. Install the two screws (M3x5) that secure the rubber foot to the display assembly.Next steps1. Install the middle cover.2. Install the speakers.3. Install the VESA-mount.4. Install the system board.5. Install the heat sink.6. Install the wireless card.7. Install the heat sink.8. Install the solid-state drive.9. Install the back cover.10. Install the stand.11. Follow the procedure in After working on your thin client.Display panelRemoving the display panelPrerequisites1. Follow the procedure in Before working on your thin client.2. Remove the stand.3. Remove the back cover.4. Remove the Vesa-mount.5. Remove the speakers.40 Removing and installing components