Dell XC Core XC760 Installation And Service Manual

2. Remove the cable cover away from the system.3. Disconnect the right control panel cable and the VGA cable from the connectors on the system board.4. Holding the right control panel and VGA cable assembly, slide the right control panel out of the system.NOTE: Observe the routing of the cable assembly as you remove the right control panel from the system.NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.Figure 181. Removing the right control panelInstalling the right control panelPrerequisites1. Follow the safety guidelines listed in the Safety instructions.2. Follow the procedure listed in the Before working inside your system.3. Remove the drive backplane cover.4. If installed, remove the air shroud or remove the GPU air shroud.5. Remove the cooling fan cage assembly.6. Remove the side wall bracket.Steps1. Align and slide the right control panel into the slot on the system.2. Route the right control panel cable through the side wall of the system.3. Align and slide the right control panel cable cover in the slot on the system.NOTE: Route the cable properly to prevent the cable from being pinched or crimped.4. Connect the right control panel cable and VGA cable to the connectors on the system board.Installing and removing system components 183