114 CablesTo disconnect a power cable with a release latch, press the release latch on thepower connector and then pull the cable up and away from the system board.To connect the power cable to the system board, align the release latch on thepower connector with the tab on the system board connector; then push theconnector downwards until it is firmly clicks into place.Power Cables Without a Release LatchThe following power cables in your system do not have a release latch:• IDE drive power cables (see "DC Power Connector P11 and P12 (BAY andBAY2)" on page 21).• Master I/O board power cable (see "DC Power Connector P14 (MS BD)"on page 22).To disconnect the power cable without a release latch, hold the cable by theconnector and pull it away from the system board or device.1 release latch 2 tab3 system board power connector 4 power connector1234
