Front I/O Panel 95Front I/O PanelRemoving the Front I/O PanelCAUTION: Before you begin any of the procedures in this section, follow thesafety instructions in the Product Information Guide.1 Follow the procedures in "Before You Begin" on page 9.2 Remove the computer cover (see "Removing the Computer Cover" onpage 13).3 Remove any full-length expansion cards (see "Removing PCI and PCIExpress Cards" on page 32).NOTICE: Carefully note the routing of each cable before you disconnect it, so thatyou are sure to re-route cables correctly. An incorrectly routed or a disconnectedcable could lead to computer problems.4 Disconnect the cables from the master I/O board.5 Remove the card fan cage (see "Removing the Card Fan" on page 69)6 Disconnect the FRONT_AUDIO_USB_LED cable, the FRONT_USB_LEDcable, and the USB_MB cable from the front I/O panel.7 Remove the drive panel (see "Removing the Drive Panel" on page 53).8 Remove the front panel:a Release the four tabs that secure the front panel to the chassis.b Carefully, pivot the front panel away from the computer to release itfrom the chassis.c Disconnect the FRONT_LED cable from the front panel to removethe front panel.
