45ENGLISH(6) “OTHER SETUP” is selectedVOLUMEENTERBANDMODEMENU FUNCTIONDISPLAY RETURN INPUT MODE SURROUNDTOP MENUSETUPSDB/TONEMUTESURR.PARASUB TITLE ANGLEAUDIORTRDS CTPTYSHIFTCH.SELECTCHT.TONETUPROG/DIRECT REPEAT A-B REPEAT RANDOMDVDTV/VCR SLEEPREMOCON MODECALL 0+10STATUSCDR/MD/TAPE TUNER/TV/VCRVCR POWERTV POWERTV POWERTVNTSC/PALMEMOPOWERCH2,3,42,3,4112 See page 40.3 Use the and cursor buttons to select thedesired setting, then press the ENTER button.• CAPTIONSUse this to set whether or not to display theclosed captions recorded on DVDs.✽ To exit the other setup modeUse the and cursor buttons to select “DVDSETUP MENU”, then press the ENTER button.• The screen returns to as it was in step 2.BCAP T I ONSONS OF F> DVD SETUP MENUDVD SETUP MENUDEC I S ION : ENTER BUTTONSEL ECT :OTHER SE TUPNOTES:• An English caption decoder is required to display Englishcaptions.• DVDs with caption signals are indicated by the ,, , mark.English captions cannot be displayed when playing DVDswhich do not contain caption signals.• The characters in which the captions are displayed(capital letters, small letters, italics, etc.) depend on theDVD and cannot be selected with this unit.Remote control unitRemote control unitENTERd4 Use the and cursor buttons to select thedesired setting, then press the ENTER button.2When “CAPTIONS” is selected:• OFF (Factory default)Select this when you do not want to display thecaptions on the screen when playing DVDscontaining English captions.• ONSelect this to display the captions on the screenwhen playing DVDs containing English captions.✽ To exit the captions modePress the ENTER button, you can go back to theprevious screen.• The screen returns to as it was in step 2.BCAP T I ONS OFFONDEC I S ION : ENTER BUTTONSEL ECT :CAP T I ONSRemote control unitRemote control unitENTERd21 LAST FUNCTION MEMORY• This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediatelybefore the power is switched off.This function eliminates the need to perform complicated resettings when the power is switched on.• The unit is also equipped with a back-up memory. This function provides memory storage when the power switch is off and withthe power cord disconnected.22 INITIALIZATION OF THE MICROPROCESSORWhen the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, theinitialization of the microprocessor is required by the following procedure.1 Press the power button to set thestandby mode, then unplug theset’s power cord from the wallpower outlet.ON / STANDBYGreen2 Hold the following PLAY (1) button and STOP (2)button, and plug the AC cord into the outlet.3 Check that the entire display is flashing with an intervalof about 1 second, and release your fingers from the 2buttons and the microprocessor will be initialized.NOTES:• If step 3 does not work, start over from step 1.• If the microprocessor is reset, all the buttons and thesetup settings are reset to the factory default values.1c 8 1:02:46DVD TONE12 2