19Connecting the ZONE2 jacksLRRLOUTPUTINPUTAUX OUTAnother roomINFRARED RETRANSMITTERPower amplifierINFRARED SENSORExtension jacks for future use.For instructions on operations using the MULTI ZONE jacks, see pages 166 ~ 179.See pages 169, 170 for the connection method of ZONE3 and ZONE4.Connecting a component with video and audio jacks to the V.AUX input jacks• To connect the video signal, connect using a 75 Ω/ohms video signal cord.R VIDEO OUT S-VIDEO OUTOPTICAL LOUTPUT R VIDEO OUT S-VIDEO OUTLOUTPUTLINE OUTVIDEO OUTS-VIDEO OUTLINE OUTDIGITAL OUTVIDEO OUTS-VIDEO OUTL RR L R LConnecting a Video game• Connect the Video game component’s outputjacks to this unit’s V. AUX INPUT jacks.Video game Video cameraConnecting a video camera• Connect the video camera component’s outputjacks to this unit’s V. AUX INPUT jacks.TRIGGER OUTTurn the DC 12V voltage on and off for the individual functionsand surround modes.For details, see “Setting the Trigger Out”. (See pages 106, 107)CONTROL terminalThese terminals are used for an exteral controller.Perform the following operation before using an externalcontroller connected to the RS-232C terminal:1. Press the ON/STANDBY button on the main unit and setthe unit to the operating mode.2. Perform the operation to turn off the power from theexternal control.3. Check that the product has been set to the standbymode.After checking the above, check the connections of theexternal controller. Operation is possible.TV2 ZONE2 preout CONNECTIONS• If another power amplifier is connected, the ZONE2 preout (variable level) jacks can be used to play a different program source in ZONE2 thesame time. (See page 166)• The ZONE2 video out is only use for the ZONE2.• The connection diagram below is an example of multi-channel playback in ZONE2. Please see page 168 when you would like to have 2-channel playback in ZONE2.
