Denon AVR-1404/484 Operating Instructions Manual

Contents

19ENGLISH2 Select the Dolby Surround Pro Logic II mode.(Main unit) (Remote control unit)• The Dolby Pro Logic indicator lights.Display Light3 Play a program source with themark.• For operating instructions, refer to themanuals of the respective components.4 Set the surround parameter mode.(Main unit) (Remote control unit)MODE cinemaDisplayTo perform this operation from the remotecontrol unit, check that the mode selectorswitch is set to “AUDIO”.5 Select the optimum mode for the source.(Main unit) (Remote control unit)or orMODE musicMODE cinemaMODE DOLBY PL6 Set the surround parameters according to themode.(Main unit) (Remote control unit)• The mode switches as shown below eachtime the button is pressed.MODE Dolby PLCINEMA EQDEFAULTMODE CINEMACINEMA EQDEFAULTMODE MUSICPANORAMADIMENSIONCENTER WIDTHDEFAULT7 Set the various surround parameters.• CINEMA EQ settingON OFFor orCINEMA EQ OFF• PANORAMA settingON OFFor orPANORAMA OFF• DIMENSION setting0 3 6or orDIMENSION 3• CENTER WIDTH setting0CENTER WIDTH 34 7or or• DEFAULT settingYES Y/N NOor orDEFAULT Y/NSelect “Yes” to reset to the factory defaults.Surround parameters qPro Logic II Mode:The Cinema mode is for use with stereo television shows and all programs encoded in Dolby Surround.The Music mode is recommended as the standard mode for autosound music systems (no video), and isoptional for A/V systems.The Dolby PL mode offers the same robust surround processing as original Pro Logic in case the sourcecontents is not of optimum quality.Select one of the modes (“Cinema”, “Music” or “Dolby PL”).Panorama Control:This mode extends the front stereo image to include the surround speakers for an exciting “wraparound”effect with side wall imaging.Select “OFF” or “ON”.Dimension Control:This control gradually adjust the soundfield either towards the front or towards the rear.The control can be set in 7 steps from 0 to 6.Center Width Control:This control adjust the center image so it may be heard only from the center speaker; only from the left/rightspeakers as a phantom image; or from all three front speakers to varying degrees.The control can be set in 8 steps from 0 to 7.21 1 34, 5, 6, 7, 85, 6, 7, 85, 6, 7, 85, 6, 7, 8112Dolby Digital mode (only with digital input) and DTS Surround (only with digital input)Playback with a digital input1 Select the input source.q Select an input source set to digital(COAXIAL/OPTICAL) (see page 12).Example: DVDw Set the input mode to “AUTO” or “DTS”.(Main unit) (Remote control unit)(Main unit) (Remote control unit)2 Select the Dolby/DTS Surround mode.(Main unit) (Remote control unit)3 Play a program source with the ,mark.DIGITAL• The DTS indicator lights whenplaying DTS sources.Light• The Dolby Digital indicator lightswhen playing Dolby Digitalsources.LightStop pressing buttons once you have completedsetting the surround parameters. After severalseconds the normal display reappears and thesettings you have made are automatically set.NOTE:• When making parameter settings, the displaywill return to the regular condition severalseconds after the last button was pressed andthe setting will be completed.Press the surround parameter button to switch to theCINEMA EQ, PANORAMA setting.