Denon AVR-1404/484 Operating Instructions Manual

Contents

9ENGLISHPoint the remote control unit at the remote controlsensor as shown on the diagram at the left.NOTES:• The remote control unit can be used from a straightdistance of approximately 7 meters, but thisdistance will shorten or operation will becomedifficult if there are obstacles between the remotecontrol unit and the remote control sensor, if theremote control sensor is exposed to direct sunlightor other strong light, or if operated from an angle.• Neon signs or other devices emitting pulse-typenoise nearby may result in malfunction, so keepthe set as far away from such devices as possible.Approx. 7 m30°30°Using the remote control unitUSING THE REMOTE CONTROL UNITFollowing the procedure outlined below, insert the batteries before using the remote control unit.Inserting the batteriesq Remove the remote controlunit’s rear cover.w Insert the R6P/AA batteries properly,as shown on the diagram.e Close the lid.NOTES:• Use only R6P/AA batteries for replacement.• Be sure the polarities are correct. (See the illustration inside the battery compartment.)• Remove the batteries if the remote control transmitter will not be used for an extended period of time.• If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contactwith clothing, etc. Clean the battery compartment thoroughly before installing new batteries.• Have replacement batteries on hand so that the old batteries can be replaced as quickly as possible when thetime comes.• Even if less than a year has passed, replace the batteries with new ones if the set does not operate even whenthe remote control unit is operated nearby the set. (The included battery is only for verifying operation. Replaceit with a new battery as soon as possible.)SETTING UP THE SYSTEM• Once all connections with other AV components have been completed as described in “CONNECTIONS”(see pages 5 to 8), make the various settings described below on the display.These settings are required to set up the listening room’s AV system centered around the this unit.SYSTEM SETUP buttonPress this to display the system setup on the display.ENTER buttonPress this to switch the display.Also use this button to complete the setting.CURSOR buttons (•, ª, 0, 1)Press this change what appears on the display.1092 Use the following buttons to set up the system:1 Set the slide switch to “AUDIO”.• System setup items and default values (set upon shipment from the factory)System setup Default settingsSpeakerConfigurationSubwoofermodeDigital InAssignmentInput the combination of speakers in yoursystem and their corresponding sizes(SMALL for regular speakers, LARGE forfull-size, full-range) to automatically set thecomposition of the signals output from thespeakers and the frequency response.This selects the subwoofer speaker for playingdeep bass signals.This assigns the digital input jacksfor the different input sources. InputsourceDigitalInputsFront Sp.LargeCenter Sp. Surround Sp. Sub WooferSmall Small YesSubwoofer mode = NormalFront & Sub Woofer Center Surround L & R3.6 m 3.6 m 3.0 mDVD/VDP TV/DBSCOAX OPTICALDelay TimeThis parameter is for optimizing the timing withwhich the audio signals are produced from thespeakers and subwoofer according to thelistening position.NOTE:• The system setup is not displayed when “HEADPHONE ONLY” is selected.