ENGLISHENGLISHEasy Setup and Operation Easy Setup and Operation10About error messages• These error displays may be displayed when performing Auto Setup measurement and the automatic measurements can not becompleted because of the speaker arrangement, measurement environment, or other factors. Please check the following matters,reset the pertinent items, and measure again.• When there is too much noise in the room, the speakers may not be detected properly. Should this happen, perform themeasurements when the noise level is low, or switch off the power of the equipment that is producing the noise for the durationof the measurements.MeasuresCauseDisplay exampleC a u t i o n : S P N o n eq The speakers required for producing suitablereproduction have not been detected.• The front L or front R speaker was notproperly detected.• Only one channel of the surround speakerswas detected.• Sound was output from the R channel whenonly one surround back speaker wasconnected.• The surround back speaker was detected, butthe surround speaker was not detected.• Check that the pertinent speakersare properly connected.w The speaker polarity is connected in reverse. • Check the polarity of the pertinentspeakers. For some speakers, thisdisplay may be displayed eventhough the speakers are properlyconnected. If so, select “Skip0”.e When accurate measurements cannot bemade due to the input level of the microphonebeing too high.• Set up the speakers so that theirposition is farther away from thelistening position.• Lower the volume of the subwooferspeaker.Press the CURSOR DD or HH button to select the items, then press the CURSOR FF button.F LC a u t i o n : P h a s eF L / RC a u t i o nO v e r l o a d < E x i tPlaying a DVD with surround sound1 Disconnect the microphone from the unit.2 Select the input source to be played.3 Select the play (surround) mode.45 Adjust the volume.Start DVD playback.