Denon AVR-1907 Operating Instructions Manual

Also see for AVR-1907: Service manual Service manual Specifications Dimensions Service manual

Contents

Denon AVR-1907 Operating Instructions Manual Manual pdf 14 page image

Easy Setup Procedure Easy Setup Procedure11ENGLISHENGLISHFront A, Front B:Assign to use the “Front A” or “Front B” speakers with bi-ampconnections.Surround Back:Assign to use as surround back speaker.When assigned to “Front” or “ZONE2”, skip the surround backchannel measurement.During the auto setup procedure, test tones are not output to“ZONE2”.ZONE2:Assign to use as “ZONE2” speakers.t Switching the front speakerPress DD HH to select “Front Sp”, then press FF GG to selectthe speaker.Front A Front B Front A+By Starting Auto SetupPress DD HH to select “Start”, then press FF.• Start the measurements.Measurement of each channel is performed as follows:FL FR C SW SL SR SBL SBR1 21: The subwoofer speaker is measured twice.2: Not displayed when “ZONE2” and “Front” are set at“Setting the Power Amplifier Assignment” ( page 53).After each channel is measured, “Calculating” appears.The display switches to the Auto Setup check screenautomatically.NOTE:• Do not change the speaker connections or subwoofer volumeafter making the measurements.• Do not turn off the power while the data is being stored.Cautions during measurements:• Loud test tones are output during the measurements. Be carefulfor example when small children are nearby.• Proper measurements may not be possible if there are obstaclesbetween the speaker and the setup microphone.• During the measurements, do not stand between or near thespeakers and setup microphone.• To avoid influencing the measurements, turn off the power of air-conditioners or any other equipment producing sound in theroom. Perform the measurements with the room as quiet aspossible.• Measurement is cancelled when VOLUME is operated while theAuto Setup is performed.e Perform the Auto Setup procedurePress DD HH to select “Auto Setup”, then press ENTER.Press SYSTEM SETUP.Press DD HH to select “Auto Setup”, then press ENTER.The message “Connect Microphone” is displayed if nomicrophone is connected. If so, connect the auto setupmicrophone.123• “System Setup” menu is not displayed when using headphones.123r Assigning power amplifiersPress DD HH to select “Power Amp Assign”, then press FFGG to set.The surround back output can be assigned to the “Front” or “ZONE2”output.¢ About automatic retryTo confirm the results of the measurements, remeasurement isautomatically performed.Remeasurement is performed up to two times. During this time,“Retry1” or “Retry2” is displayed on the screen.