Denon AVR-1907 Operating Instructions Manual

Also see for AVR-1907: Service manual Service manual Specifications Dimensions Service manual

Contents

Denon AVR-1907 Operating Instructions Manual Manual pdf 60 page image

ENGLISH57ENGLISHAdvanced Setup – Part 2Advanced Setup – Part 2¢ Adjusting the test tone using the remote controlunitAdjustment of the test tones using the remote control unit is onlypossible in the “Auto” mode and only valid in the STANDARD (Dolby/DTS Surround) mode. The adjusted levels are automatically stored forthe different surround modes.Press [TEST TONE].• Test tones are output from the different speakers.Press [TEST TONE].Press FF GG to adjust the volume.123Setting the Crossover FrequencySet the frequency (Hz) below which the bass sound of the variousspeakers is to be output from the subwoofer.For speakers that are set to “Small”, frequencies under the crossoverfrequency are cut before the signal is output, and the low frequencycomponent that was cut is output from the subwoofer or thespeakers that are set to “Large”.Press DD HH to select “Crossover Frequency”, thenpress ENTER.1Press FF GG to set.40, 60, 80, 90, 100, 110, 120, 150, 200, 250 Hz:Set as desired according to your speakers’ bass playback ability.2Press ENTER.3• The crossover frequency mode is valid only when subwoofer is setto “ON”, and when one or more speakers are set to “Small”, asdescribed in section “Setting the Speaker Configuration” ( page54, 55).• If “LFE+Main” is set at “Subwoofer Setup”, “SW:LFE+Main” (page 55) is displayed at the top right of the screen.• Set to “80 Hz” when using regular speakers. When using smallspeakers, we recommend setting to a higher frequency.1 2