Denon AVR-1907 Operating Instructions Manual

Also see for AVR-1907: Service manual Service manual Specifications Dimensions Service manual

Contents

Denon AVR-1907 Operating Instructions Manual Manual pdf 58 page image

ENGLISH55ENGLISHAdvanced Setup – Part 2 Advanced Setup – Part 2Press ENTER.A subwoofer with sufficient low frequency playback capability canbetter handle deep bass than most main and surround speakers,and the system’s overall performance will be greatly enhancedwhen “Small” is set for the main (front) and surround speakers.When “Front” is set to “Small”, “Subwoofer” is automatically setto “Yes”, and when “Subwoofer” is set to “No”, “Front” isautomatically set to “Large”.4• Select “Large” or “Small” not according to the actual size of the speakerbut according to the speaker’s capacity for playing low frequency(bass sound below the frequency set for the Crossover Frequency)signals. If you do not know, try comparing the sound at both settings(setting the volume to a level low enough so as not to damage thespeakers) to determine the proper setting.123Setting the Subwoofer SetupSelect the method of playback of the subwoofer for playing the lowbass signals.Press DD HH to select “Subwoofer Setup”, then pressENTER.Press FF GG to set.LFE (Normal):For any channel(s) that are set to “Large”, low frequencies in thatchannel’s corresponding source are directed to that loudspeakeronly. The low frequencies played from the subwoofer are only theLFE signals and the low frequencies of channels set to “Small”.LFE+Main:Low frequencies from speaker channels that have been set to“Large” are reproduced from those speakers as well as from thesubwoofer(s).• The subwoofer mode setting is only valid when and “Yes” is set forthe subwoofer in the “Setting the Speaker Configuration”.• Select the “LFE+Main” mode if you want low frequency signals toalways be played from the subwoofer channel.• Select the mode achieving a voluminous bass sound when playingmusic or movie sources.Press ENTER.123Setting the DistanceThis parameter is for optimizing the timing with which the audiosignals are produced from the speakers and subwoofer according tothe listening position.Preparations:Measure the distances between the listening position and thespeakers (L1 to L8 on the diagram at the below).Press DD HH to select “Distance”, then press ENTER.L1 L2L3L8L4 L5L6 L7C FRFLSWListening positionSL SRSBL SBR11 2Press DD HH to select the speaker, then press FF GG to set.2Press ENTER.3Center speakerFront speakerSubwooferSurround speakerSurround back speaker