Denon AVR-1908 Owner's Manual

Also see for AVR-1908: Specifications Comparison chart Specifications Owner's manual Service manual

Denon AVR-1908 Owner's Manual Manual pdf 26 page image

ENGLISHError MessagesIf the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message isdisplayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure overagain.NOTE Be sure to turn the power off before checking the speaker connections.Room EQSelect room EQ setting method.[Selectable items]All : Apply settings to all surround modes.Assign : Make settings for each surround mode separately.s OptionMake various other settings.Select “Retry” to measure again.Getting Started Connections Setup Playback Remote Control Multi-Zone Information TroubleshootingDirect Mode SetupSelect room EQ use for DIRECT or PURE DIRECT mode.[Selectable items]ON : Use room EQ.OFF : Do not use room EQ.d Parameter CheckCheck auto setup measurement results.This is displayed after the auto setup procedure is completed.The auto setup results can be set again when “Restore” is selected.[Selectable items]Speaker Config. Check Distance CheckChannel Level Check Crossover Freq. CheckEQ CheckError messages (examples) Cause MeasuresorRetryCancelMicrophone:NoneSpeaker :NoneAuto SetupCaution!Audyssey MultEQ• Included setup microphone is not connected.• Not all speakers could be detected.• Connect the included setup microphone to the SETUPMIC jack on the main unit.• Check the speaker connections.too high orRetryCancelAmbient noise isLevel is too low.Auto SetupCaution!Audyssey MultEQ• Too much noise in the room for accuratemeasurements to be made.• Speaker or subwoofer sound is too low foraccurate measurements to be made.• Either turn off any device generating noise or move itaway.• Try again when the surroundings are quieter.• Check the speaker installation and the direction inwhich the speakers are facing.• Adjust the subwoofer’s volume.RetryR :NoneCancelFrontAuto SetupCaution!Audyssey MultEQ• Displayed speaker could not be detected.· The front R speaker were not properlydetected.· Only one channel of the surround speakerswas detected.· Sound was output from the R channelwhen only one surround back speaker wasconnected.· The surround back, but the surround speakerwas not detected.• Check the connections of the displayed speaker.RetryL :PhaseCancelSkipFrontAuto SetupCaution!Audyssey MultEQ• Displayed speaker connected with thepolarities reversed.• Check the polarities of the displayed speaker.• For some speakers, this error message may bedisplayed even if the speaker is properly connected. Ifyou are sure that the wiring is correct, select “Skip”.