|
ENGLISH About the button names in these explanations< > : Buttons on the main unit[ ] : Buttons on the remote control unitButton name only:Buttons on the main unit and remote control unitGetting Started Connections Setup Playback Remote Control Multi-Zone Information TroubleshootingQuick Select FunctionWith this function, the currently playing input source, input mode,surround mode, room EQ settings and volume can be stored inthe memory.1 Set the input source, input mode, surround mode,room EQ settings and volume to the conditions youwant to store.2 Press and hold the desired until“Memory” appears on the display.• To call out the settings, press at which the desiredsettings were stored.• The Quick Select name can be changed (vpage 30).NOTEInput sources stored with the quick select function cannot be selectedif they have been deleted at menu “Manual Setup” – “Option Setup”– “Source Delete” (vpage 29). In this case, store them again.Input Source VolumeQuick Select 1 DVD/HDP –40 dBQuick Select 2 TV/CBL –40 dBQuick Select 3 VCR –40 dB[Quick Select Defaults]Personal Memory Plus FunctionThis function sets the settings (input mode, surround mode, etc.)last selected for the individual input sources.When you switch to an input source, the settings are automaticallyset to the ones that were set the last time that input source wasused.The surround parameters, tone control, room EQ settings and thevolumes of the different speakers are stored for the individual surroundmodes.Last Function MemoryThis stores the settings as they were directly before the standbymode was set.When the power is turned back on, the settings are restored to asthey were directly before the standby mode was set.Backup MemoryThe various settings are backed up for about 1 week, even if thepower is turned off or the power cord is disconnected.Resetting the MicroprocessorPerform this procedure if the display is abnormal or if operationscannot be performed.When the microprocessor is reset, all the settings are reset totheir default values.1 Turn off the power using .2 Press while simultaneously pressing and .3 Once the display starts flashing at intervals of about 1second, release the two buttons.If in step 3 the display does not flash at intervals of about 1 second,start over from step 1.
|
