ENGLISH• Channel LevelAdjust channel levels to.obtain equal volume from all speakers.Test ToneSelect test tone playback method.[Selectable items]I Auto I: Automatically switch speaker from which test tone isoutputManual : Manually switch speaker from which test tone is output.Test Tone StartOutput test tone.[Variable range] OFF * -12dB - IOdB I - +12dB* In the case of a sub woofer, reducing the volume when it is at "-12dB" will change the setting to "OFF" (none).DefaultResets the settings to the default values.~ Operating from the main remote control unitAdjusting with the main remote control unit using the test tones isonly possible in the" Auto" mode and only effective in the STANDARDmode. The adjusted levels for the different modes are automaticallystored in the memory.[Adjusting using test tones]Q) Press [TESnTest tones are output from the various speakers.CV Use t> to adjust so that the volume is equal for all speakers.® When the adjustments are completed, press [TESn again.-When the menu "Speaker Configuration" - "Surround BackSpeaker" setting (Gf'page 30) is set to "lspkr", the surround backspeaker display is set to "Surround Back Sp." .- Speakers set to "None" in the "Speaker Configuration" settings arenot displayed.- When "Channel Level" is adjusted, the adjusted values are set for allthe surround modes. To adjust the channel level separately for thedifferent surround modes, use the operation see page 63.II Crossover FrequencySelect crossover frequency from which subwoofer handles lowrange signal.[Selectable items]40Hz 60Hz 180Hz 190Hz 100Hz 110Hz 120Hz 150Hz200Hz 250HzOnly the portion of the bass sound of the various speakers outputfrom the subwoofer that has a frequency below the frequency sethere is outputSet this according to the low frequency reproduction capabilities ofthe speakers you are using.AdvancedSet the crossover frequency separately for the different speakers..~-If in the "Advanced" settings, "Subwoofer Setup" (Gf'page 30)in the menu is set to "LFE", it is possible to make this settingfor speakers set to "Small" at "Speaker Configuration". If set to"LFE+Main", this setting can be made regardless of the speakersize.- For speakers set to "Small", sound below the crossover frequencyis cut from the sound output The cut bass sound is output from thesubwoofer or front speakers.- Always set the crossover frequency to "80 Hz". When using smallspeakers, however, we recommend setting the crossover frequencyto a higher frequency.II Front Speaker SetupSelect front speakers to use for each surround mode.[Selectable items]INonnal I: To change the settings, select "Custom".Custom Make separate settings for 2-channel mode.When set to "Custom", you can select beforehand the front speakerto use for each surround mode.[Selectable items]DIRECT/STEREO: [IJ B A+BMULTI CH: [IJ B A+B-N·h.When set to "Custom", does not operate .31 I For details on how to select, set and cancel settings for each menu, see "Menu Operations" (~page 221.
