ENGLISHIISymbols used to indicate buttons in this manualButton locatedonboth the main unitandthe remote controlunit•BUTIONButton onlyonthe main unit•Button onlyonthe remote control unit•[BUTIONIMODE>'-r---jr-"-f~-"~[;jQUICKSELECTQUICKSELECTirf!S~JJ2~~0J[Front][Rear]'<;5-:<11>._)~~--f::::.V--+----:8-'"'.'--10:---1[CHSELECT/ENTER]63Operations1Connect the HOMI to the AVR-1909 with equipmentcompatible with the HOMI control function (lGFpage62).2Put the power on for all the equipment connected totheHOMI.3Check the settings for all the equipment connected tothe HOMI and make HOMI available to them.'*Pleaseconsulttheoperatinginstructionsfortheconnectedequipment to check the settings.'*Steps1-3do nothaveto be repeated once started.'*Carryout steps 2and3 should anyofthe equipmentbepluggedout.4Switch the television input to the HOMI connected tothe AVR-1909.5Switch the AVR-1909 input to the HOMI input sourceand checkifthe picture from the playerisok.6Put the television poweron"standby and checkiftheAVR-1909 goes into standby.If theAVR-1909does not work please check the following.•Isthe menu "Manual Setup" -"HOMI Setup" -"HOMI Control"((Fpage32)set to "ON"?•Isthemenu"Manual Setup" - "HOMI Setup" - "Power Off Control"((Fpage32)set to "ON"?•Isthe control function used for the television HOMI properly set7(Checkthe television operating instructions for details.)• Shouldanyof the operations belowbeperformed, the interlockingfunction maybereset,inwhich case, repeat step's 2and3• Menu "Input Setup" - "Assign" - "HOMI In"(D2W"page42)settinghaschanged.• Thereisa change to the connection between the equipmenandthe HOMI, oranincreaseinequipment.Channel LevelYoucan adjust the channel level either according to the playbacksources or to suit your taste,asdescribed below.1Pressor[CHSELECT/ENTER].ChanneIVoI urneIISRO.odBO.OdBSBRO.odBFRO.OdBSBLO.odBSWO.OdBSLO.odBFade rFRONTC .REAR2UseL:::.\l,or[CHSELECT/ENTER]to select the speaker.The speaker thatcanbeset switches each time one of thebuttonsispressed.3Use<1I>toadjust the volume.'*Inthe caseofa sub woofer, reducing the volume when itisat"-12dB"will change the setting to "OFF" (none).-N,n.When the input sourceis"iPod':youcannot perform channellevelsetting.Fader FunctionThis function lets you adjust(fade)the sound fromallthe front orrear speakers at once.1Pressor[CHSELECT/ENTER].2PressL:::.\l,or[CHSELECTIENTER]to select "Fader".._--._-_._--_._-3Use<11>to adjust the volumeofthe speakers.(front,[>:rear)• The fader function does not affect the subwoofer.•Thefadercanbeadjusted until the volumeofthe speaker adjustedto the lowest valueis-12dB.
