Denon AVR-1910 Owner's Manual

Also see for AVR1910 - Multi-Zone Home Theater Receiver: Specifications Specification Capabilites and Compatibilities Service manual Getting started

2Getting Started Connections Playback Remote Control Information Troubleshooting SpecificationsENGLISH Multi-ZoneSetting items Setting contentsAuto Surround ModeMake setting for memorizingsurround mode setting foreach input signal type.ON : Memorize settings. Most recently stored surround mode isautomatically selected.OFF : Do not memorize settings. Surround mode does not changeaccording to input signal.The auto surround mode function lets you store in the memory thesurround mode last used for playing the four types of input signalslisted below.q Analog and PCM 2-channel signalsw Dolby Digital and DTS 2-channel signalse Dolby Digital and DTS multi-channel signalsr Multi-channel signals other than Dolby Digital and DTS (PCM, etc.)NOTEWhen playing in the PURE DIRECT mode, the surround mode does notchange even if the input signal is changed.EQ CustomizeSet so that unused equalizersettings are not displayedwhen is used.Audyssey Byp. L/R / Audyssey Flat / ManualUsedNot UsedNOTE• Set so that the “Audyssey Byp. L/R” and “Audyssey Flat” settings can bemade when the Audyssey Auto Setup procedure is performed.• Equalizer settings for which “Not Used” is set with the Quick Selectfunction cannot be stored and called out.••Setting items Setting contentsEXT.IN SW LevelSet the playback level of theanalog subwoofer signalsinput from the external inputterminals (EXT.IN).+15dB : This is the recommended level.+10dB / +5dB / 0dB : Select the level according to the player being used.2ch DIRECT/STEREOMake speaker settings for 2-channel mode playback.Setting : Select the method for setting the speakers used in the 2-channeldirect and stereo playback modes.Basic : The settings at “Speaker Setup” (vpage 25) are applied.Custom : Make separate settings for 2-channel mode.Front : Set the front speaker size.Large : Use of a large speaker that can adequately play back lowfrequencies.Small : Use of a small speaker that has inadequate playback capacityfor low frequencies.SW : Set the presence of a subwoofer.Yes : Use a subwoofer.No : Select when a subwoofer is not connected.SW Mode : Select low range signal to be reproduced by subwoofer.LFE : Add the low frequency signal of the channel for which the speakersize is set to “Small” to the subwoofer signal and output it.LFE+Main : Add the low frequency signal of all channels to thesubwoofer signal and output it.Crossover : Outputs at below set frequency, each speaker’s bass signaloutput from the subwoofer.40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz/ 250HzDistance FL / Distance FR : Select the speaker you want to set, and setthe CH Level. Set the value that is closest to the measured distance.0.0ft ~ 60.0ft (12.0ft) / 0.00m ~ 18.00m (3.6m)CH Level FL/ CH Level FL FR : Select the speaker you want to set, andset the CH Level. Adjust the level of each channel.–12.0dB ~ +12.0dB(0.0dB)•••••••••••Make settings for audio playback.Making the audio settings (Audio Setup)Default settings are underlined.Making detailed settings (Manual Setup): Moves the cursor (Up/Down/Left/Right) : Decision the setting : Return to previous menuRemote controloperation buttons : Displaying the menuCancel the menuSettings