Denon AVR-985 Operating Instructions Manual

Also see for AVR 2805 - AV Receiver: Control protocol Manual

Contents

Denon AVR-985 Operating Instructions Manual Manual pdf 9 page image

9VIDEO OUTY CRCBCOMPONENTBVIDEO INY CRCBCOMPONENTConnecting the video component equipped with Color Difference (Component - Y, PR /CR ,P B/C B ) Video jacks• When making connections, also refer to the operating instructions of the other components.• The signals input to the color difference (component) video jacks are not outputs to the VIDEO output jack (yellow) or the S-Video output jack.• Some video sources with component video outputs are labeled Y, C B, C R, or Y, Pb, Pr, or Y, R-Y, B-Y. These terms all refer to component videocolor difference output.• The function assigned to the component video input can be changed at the system setup. For details, see “Setting the Video Input Mode”.(See page 41)DVD player Connecting a DVD playerDVD IN jacks• Connect the DVD player’s color difference (component) video output jacks(COMPONENT VIDEO OUTPUT) to the COMPONENT VIDEO-1 IN jack using75 Ω/ohms coaxial video pin-plug cords.• In the same way, another video source with component video outputs suchas a TV/DBS tuner, etc., can be connected to the VIDEO-2 color difference(component) video jacks.Monitor TVConnecting a monitor TVMONITOR OUT jack• Connect the TV’s color difference (component) video input jacks(COMPONENT VIDEO INPUT) to the COMPONENT MONITOR OUTjack using 75 Ω/ohms coaxial video pin-plug cords.• The color difference input jacks may be indicated differently onsome TVs, monitors or video components (“C R, CB and Y”, “R-Y, B-Y and Y”, “Pr, Pb and Y”, etc.). For details, carefully read theoperating instructions included with the TV or other component.NOTE:Down-converting from the component video signal to the S-Videoand composite video signal is not possible, so when not using thecomponent video monitor output terminal connect the player usingthe S-Video or composite video input terminal.Cautions on the video conversion function:When the component video terminals are used to connect the AVR-2805/985 with a TV (or monitor, projector, etc.) and the video (yellow)or S video terminals are used to connect the AVR-2805/985 with aVTR, depending on the combination of the TV and VTR the picturemay flicker in the horizontal direction, be distorted, be out of sync ornot display at all when playing video tapes.If this happens, connect a commercially available video stabilizer, etc.,with a TBC (time base corrector) function between the AVR-2805/985and the VTR, or if your VTR has a TBC function, turn it on.MONITOR OUT jacksThe AVR-2805/985 is equipped with a function for up-convertingvideo signals.Because of this, the AVR-2805/985’s MONITOR OUT jack can beconnected to the monitor (TV) with a set of cables offering a higherquality connection, regardless of how the player and the AVR-2805/985’s video input jacks are connected.Generally speaking, connections using the component video jacksoffer the highest quality playback, followed by connections using theS-Video jacks, then connections using the regular video jacks(yellow).(S-Video jack)(Color Diffrence Video jack)(Video jack) (Video jack)(Color Diffrence Video jack)(S-Video jack)The Video Conversion FunctionWith the AVR-2805/985, the Video signal and the S-video signalwhich were inputted are converted mutually. And also theVideo signal and the S-Video signal which were inputted areconverted into a higher quality.This unit’s input jacks This unit’s output jacksThe flow of thethis unit’s internalsignals.