Denon CEOL RCD-N8 Owner's Manual

Also see for CEOL RCD-N8: Service manual

6NOTE• Do not plug in the power cord until all connections have beencompleted.• When making connections, also refer to the operating instructions ofthe other components.• Be sure to connect the left and right channels properly (left with left,right with right).• Do not bundle power cords together with connection cables. Doingso can result in humming or noise.Cables used for connectionsAudio cable (sold separately)Subwoofer cableSpeaker cableOptical cableAudio cable RLRLStereo mini-plug cableConnectionsConnecting the speakersw qw q(R)(L)INSpeakersSubwooferwith built-inamplifierConnecting the speaker cablesCarefully check the left (L) and right (R) channels and + (red) and –(black) polarities on the speakers being connected to this unit, and besure to interconnect the channels and polarities correctly.1 Peel off about 10 mm of sheathing fromthe tip of the speaker cable, then eithertwist the core wire tightly or terminate it.2 Turn the speaker terminalcounterclockwise to loosen it.3 Insert the speaker cable’s core wire tothe hilt into the speaker terminal.4 Turn the speaker terminal clockwise totighten it.NOTE• Disconnect this unit’s power plug from the power outlet beforeconnecting the speakers. Also, turn off the subwoofer.• Use speakers with an impedance of 4 to 16 Ω. The protectioncircuit may be activated if speakers with an impedance otherthan specified are used.• Connect the speaker cables so they do not stick out of thespeaker terminals. The protection circuit may be activated if thewires touch the rear panel or if the + and – sides touch eachother (vpage 59 “Protection circuit”).• Never touch the speaker terminals while the power supply isconnected. Doing so could result in electric shock.