ENGLISHTroubleshootingInformationHDMI Control FunctionPlaybackSetupConnections SpecificationsInserting the BatteriesAbout the Remote Control Unite Put the rear cover back on.q Remove the remote controlunit’s rear cover.w Set three R6/AA batteries inthe battery compartment in theindicated direction.NOTEUse R6/AA batteries in this remote control.Replace the batteries with new ones if the set does not operateeven when the remote control unit is operated close to the unit.(The supplied batteries are only for verifying operation.)When inserting the batteries, be sure to do so in the proper direction,following the “q” and “w” marks in the battery compartment.To prevent damage or leakage of battery fluid:Do not use a new battery together with an old one.Do not use two different types of batteries.Do not attempt to charge dry batteries.Do not short-circuit, disassemble, heat or dispose of batteries inflames.If the battery fluid should leak, carefully wipe the fluid off the insideof the battery compartment and insert new batteries.Remove the batteries from the remote control unit if it will not be inuse for long periods.Used batteries should be disposed of in accordance with the localregulations regarding battery disposal.•••••••Operating Range of the Remote ControlUnitPoint the remote control unit at the remote sensor when operatingit.30°30°Approx. 7 mNOTEThe set may function improperly or the remote control unit may notoperate if the remote control sensor is exposed to direct sunlight,strong artificial light from an inverter type fluorescent lamp or infraredlight.Remote Control Settings (RemoteControl Side)Switches when the DBP-4010UD’s remote control operatesanother DENON BD players in the vicinity.Set the remote control code simultaneously on the main unit, too.For how to set codes, see GUI menu: “Other Setup” – “RemoteControl Setting” – “Remote ID” (vpage 31).GRemote control code settingH1 : Set the remote control code to “1”.2 : Set the remote control code to “2”.If the signal code of the remote control does not match the signalcode of the unit, the remote control code set on the unit is shownon the display.GExampleHIf the code setting on the unit is “DENON 1”, and the setting on theremote control is “2”, “PLAYER 1” is shown on the display.NOTEMatch the signal code of the remote control with the signal code ofthe unit. If the remote control code is different, you cannot operatethe DBP-4010UD with the remote control.Even if you change the remote control code, set GUI menu “OtherSetup” – “Remote Control setting” – “Receive Legacy Remocon”(vpage 31) to “Off” when operating the DBP-4010UD with aremote control other than DENON’s.•••Getting Started