ENGLISHTroubleshootingInformationPlaybackSetupConnectionsGetting Started SpecificationsPlaybackOperations Enabled During PlaybackDuring playback of a BD or DVD-Video recorded with severalcamera angles, you can change the angle.Switching the AngleBD DVD-VNOTEAngle changing may be restricted, depending on the disc.1 Press during playback.The angle number currently being played is displayed.Angle1/32 Use to select angle.Angle2/33 Press .The setup screen disappears.Press .The display brightness each time the button ispressed.Normal Dim Dark OffChanging the Brightness of theDisplay (Dimmer Control)Even when “Off” is selected, the status of operations that areperformed appears momentarily on the display if “Display Setup”– “Temporary Display” on the GUI menu is set to “On” (vpage 30).When you make an HDMI connection with a TV or AV Amp compatiblewith DBP-4010UD and HDMI control functions, you can perform thefollowing operations by setting the HDMI control function of eachdevice.TV or AV Amp power is turned on by operatingthe DBP-4010UD, and functions change with DBP-4010UD input.Turning off the TV’s power turns the DBP-4010UD’spower to standby.Operating the DBP-4010UD via the TV’s remotecontrol.(When the TV’s remote control has player operation buttons)nnnIf the HDMI control function does not operate properly, check thefollowing points.Is the TV or AV Amp compatible with the HDMI control function?Are the HDMI control function settings of all equipment correct?(Step 3)After setting, did you add another HDMI device connection ormake any changes in the connections? In this case, perform settingagain.•••HDMI Control FunctionNOTEThe HDMI control function controls operations of a TV that iscompatible with the HDMI control function. Make sure that the TVand HDMI are connected when you perform HDMI control.Some functions may not operate depending on the connected TVor AV Amp. Check the owner’s manual of each device for detailsbeforehand.When “Other Setup” – “Power Saving” on the GUI menu is setto “Power Saving Standby” or “Normal Standby” (vpage 31),the player’s power cannot be turned on using the HDMI controlfunction.When “HDMI Setup” – “HDMI Control” – “Power Off Control” on theGUI menu is set to “Off” (vpage 24), the DBP-4010UD is not setto standby even if the connected device is in the standby mode.When “DENON LINK Setup” – “DENON LINK Mode” on the GUImenu is set to “4th”, the HDMI control function is enabled for theconnected devices.•••••1 Set HDMI control function to “On”.On the GUI menu, set “HDMI Setup” – “HDMI Control” (vpage24).2 Turn the power on for all the equipment connected byHDMI cable.3 Set the HDMI control function for all equipmentconnected by HDMI cable.On the GUI menu, set the DBP-4010UD with “HDMI Setup”– “HDMI Control” (vpage 24).Please refer to the owner’s manual as regards setting of connecteddevices.Carry out Steps 2 and 3 should any of the equipment beunplugged.bb4 To ensure that the DBP-4010UD’s HDMI video outputis projected on the TV screen, change the inputfunction of the TV and AV Amp.5 When you turn the TV’s power to standby, check thatthe power of the DBP-4010UD and AV Amp also goeson standby.HDMI Control Function