Denon DBP-4010UD Owner's Manual

Contents

TroubleshootingInformationHDMI Control FunctionPlaybackSetupGetting Started SpecificationsENGLISH2. Playing Back with a Direct Connection to a TVCheck the television’s audio and video terminals and make the connection to one of them."6%*0"6%*0*/-37*%&0*/7*%&0 7*%&0*/47*%&07*%&0$0.10/&/57*%&0: 1# 1 3*/ */)%.*R LR LTVAudio terminals Video terminal S-Video inputterminalComponent videoinput terminalHDMI inputterminalTV TV TV TV(Soldseparately)(supplied)(supplied) (Soldseparately)(Soldseparately)NOTEDo not connect the DBP-4010UD’s video output via a VCR (Video Cassette Recorder). Some media containcopy prohibit signals, which will disturb the screen image.When playing NTSC disc, DBP-4010UD’s video output becomes NTSC signal format.When playing PAL disc, DBP-4010UD’s video output becomes PAL signal format.When connected to the television’s component video input terminalThe DBP-4010UD’s component video output supports 480i/576i/480p/576p/720p/1080i output. Matchthe output to the corresponding resolution of the connected television by setting, on the GUI menu:“Video Setup” – “Component Resolution” (vpage 24). Images will not be projected normally if thetelevision resolution and DBP-4010UD’s output resolution do not match. Copyright protected DVD isoutput in 480i/576i or 480p/576p.n•NOTEWhen you press and set it to “HDMI On”, no video signals are output from the component videoterminals. When using the component video terminals, set HDMI mode to “HDMI Off”.When connected to the HDMI input terminalOutputting both digital video and digital audio signals.See “Required Settings for HDMI Connection” (vpage 13) for HDMI video output and audio outputsettings.n3. Playing Back 2-Channel AudioConnecting to a Device with Analog 2-channel Audio InputTerminal with Stereo Pin Plug Cable"6%*0"6%*0*/-3 RLRLStereoFor software recorded in multi-channel, analog signals that have been down-mixed into 2 channelsare output."6%*0"6%*0*/-3 RLRLStereoFor software recorded in multi-channel, analog signals that have been down-mixed into 2 channelsare output.When connecting using the analog 2-channel audio output terminalsWhen connecting using the analog 7.1-channel audio output terminalsOn the GUI menu, select “Audio Setup” – “7.1ch Audio Out”, and set it to “2 channel” (vpage 25).Connections